LGP Series
Pleated coalescing cartridge with meltblown drainage layer for the removal of fine liquid aerosols from process gas streams.
The LGP series is a range of liquid-gas coalescing cartridges combining a pleated glass microfiber media with an outer meltblown drainage layer, developed to remove fine liquid aerosols from gas streams. The media merges the aerosols into larger droplets, which the drainage layer carries down to the base of the filter.
LGP cartridges are designed for liquid-gas coalescing applications requiring very high separation efficiency, stable pressure drop and good performance in the event of flow interruption.
The drainage materials are naturally oleophilic, with no surface treatment liable to degrade. The end caps are thermally welded, with no resin or adhesive, for greater robustness and a reduced risk of detachment.
The series is available in standard format (66 mm diameter) and large format (153 mm diameter), in three lengths.
LGP cartridges are particularly suited for:
- protection of compressors and turbines against entrained solids and liquids;
- gas treatment, to limit losses and foaming of amines and glycols;
- protection of low and ultra-low NOx burners;
- protection of separation membranes and molecular sieves;
- removal of lubricating oil from ammonia gas;
- biogas treatment prior to compression, and gas transmission lines.
- Pleated glass microfiber coalescing media
- Meltblown drainage layer in polypropylene (PP) or polyester
- Support and cage in 304 stainless steel
- End caps in polypropylene (PP) or nylon (PA), thermally welded with no resin or adhesive
- Seals: Viton® as standard
- 99.99 % efficiency with less than 3 ppbw residual oil downstream (modified CAGI-400)
- 99.9999 % efficiency at 0.1 µm on solid particles (EN 13274-7)
- Maximum temperature: 82 °C; 65 °C for the 11B version in the presence of water
- Outside diameter: 66 mm (standard format) or 153 mm (Plus format)
- Nominal lengths: 10″ (254 mm), 30″ (762 mm) or 40″ (1,016 mm)
- End configurations: DOE, Code 2 or SOE (153 mm diameter)
- Operating pressure rated to customer requirements
- Standard construction in polypropylene, polyester where process conditions require it
- Direct replacement for Pall Seprasol and Seprasol Plus cartridges (e.g. CC3LGB7H13, CS604LGH13)
- Typical part number: 11A-(end cap)-G0X-(length)-(end configuration)-V-A, e.g. 11ACG0X-40AVA